iRule  Universal Remote Control

Support Center

Use Case - Changing Images Based on Feedback

Last Updated: Sep 29, 2015 01:27PM EDT

Below is a step-by-step list on how to change an image based on feedback.

In this example we are tracking the Mute state of an Integra receiver.

  1. Open Builder
  2. Go to Feedbacks tab and open your feedback
  3. Assign variable name to second layer of feedback
  4. Assign variable name to your image
  5. Drag feedback to page
  6. Enter macro view
  7. Add logic
  8. Save & Sync


Step 1: Open Builder 

Step 2: Open feedbacks tab and your Mute textual feedback 

Step 3. Assign variable name within properties window 

--- The properties window can be found in the lower left corner of the builder

--- In this example we are using the variable name of mute

Step 4: Assign variable name to your image by double clicking on the image

-- You are double clicking on the image found on the GUI and assigning the variable to the state of the image you would like to change. 

Step 5: Add feedback to your page  
-- You need to add the feedback to your page. You can set the color to clear if you dont want the feedback to show on your page.

Step 6: Enter macro view of feedback by double clicking on the feedback

Step 6: Add logic 

- The Left-hand operator is your variable name from Step 3

- The Right-hand operator is the Replace with value of your feedback

Step 7: Save and Sync 

Recent Discussions

seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found
There was an error contacting Get Satisfaction
View All